AEROX TC DROOP GAUGE SET & 10mm BLOCKS

Introducing the new Aerox droop gauge set for 1-10th Touring cars.

A new universal way to take the confusion out of measuring droop across different chassis manufacturers.

Droop is a measurement used to define the point at which the tyre leaves contact with the ground. It can be a very powerful tool to quickly change the behaviour of a car. Measuring droop to the axle centre is the most accurate way of doing so, as it eliminates any potential discrepancy in the symmetry of suspension components. This method is also the only correct way to quickly and easily compare droop across different cars, without the need to
account for any differences in car design.

Using the Aerox system is simple. Fasten the droop wheels on to one pair of axles. The chassis sits on the 10mm droop blocks. The droop gauge is used to measure to the lowest part of the droop wheel. The reading from the gauge is the distance from chassis underside to the centre of axle. Repeat for the other pair of axles.

For easy storage and transportation, the M4 grub screw is inserted into the side of the droop gauge so that it protrudes
equally out of both sides. This is then locked off with the M3 grub screw from the underside. The droop wheels then attach to the droop gauge via the M4 grub screw for safe storage.

Introducing the new Aerox droop gauge set for 1-10th Touring cars.

A new universal way to take the confusion out of measuring droop across different chassis manufacturers.

Droop is a measurement used to define the point at which the tyre leaves contact with the ground. It can be a very powerful tool to quickly change the behaviour of a car. Measuring droop to the axle centre is the most accurate way of doing so, as it eliminates any potential discrepancy in the symmetry of suspension components. This method is also the only correct way to quickly and easily compare droop across different cars, without the need to
account for any differences in car design.

Using the Aerox system is simple. Fasten the droop wheels on to one pair of axles. The chassis sits on the 10mm droop blocks. The droop gauge is used to measure to the lowest part of the droop wheel. The reading from the gauge is the distance from chassis underside to the centre of axle. Repeat for the other pair of axles.

For easy storage and transportation, the M4 grub screw is inserted into the side of the droop gauge so that it protrudes
equally out of both sides. This is then locked off with the M3 grub screw from the underside. The droop wheels then attach to the droop gauge via the M4 grub screw for safe storage.

Please note: You will have to use 10mm Blocks. Not supplied in this kit.

With a new venture into Electronics, Aerox has sourced some of the highest performing LiPo batteries in the world.

The range includes a wide variety of battery specs for 1/12th On Road, 1/10th On and Off Road.  All supplied in a hard case with 5mm plugs and awesome Aerox styling.  The batteries have been selected for High C rating and low internal resistance which makes them especially good for Stock Racing but equally at home with the high power demands of Modified Racing.

Specifications

Capacity: 6300mAh
Nominal Voltage: 7.6V
Discharge C Rate: 150C
Max Charge C Rate: 3C
Dimension:(L*W*H)139*47*23 mm
Connector: 5mm bullet
Weight: 278g
47.9Wh
Suitable for: Touring Car Stock and Modified.
BRCA and EFRA Legal from April 1st.